“Excellent, easy to use website. Good communication with regards to logo quality. Sign arrived in good time, is good quality and looks good at our office.”
- Looking for more information?
- Ask a question and our experts will answer it.
Product Details
Our most popular custom wall covering, your design printed on the best wall vinyl in the world, Mactac WW300! Send us your design and our studio will split it into drops for you to easily install
Simply enter the size of your wall to grab an instant price or contact our team if you have a more complex project in mind for a custom quotation.
Our vinyl wall graphic material is a peel and stick product, all you have to do is remove the backing sheet to reveal the special wall adhesive and apply to your wall surface like a large sticker.
Your graphic will be produced on our high quality digital printers and coated with a protective laminate which can be either matt or gloss finish. All of our custom wall coverings are split into drops and supplied with 10mm overlaps to make installation easier.
We advise that when ordering your wall graphics online that you add 100mm extra length to your drops to cover any inconsistency in your wall height and also add 100mm to the width. Vinyl is very easy to trim so by adding this extra you will make sure that you don't fall short when it comes to installation
If you would prefer your graphics are professionally installed then please get in touch and we can give you a custom quotation.
What's included with this purchase:
- 1 x Vinyl wall graphic printed on high tack wall vinyl supplied in drops with protective laminate
Wall Assessment
Ensure the wall is smooth, ideally with a satin or gloss paint finish. Certain paint additives, low latex, and VOC levels can reduce adhesive bond. Avoid 'easy care' and 'easy clean' paints.
If unsure of the paint type, trial a sample print for 24 hours before full installation. Apply a primer if there is any doubt about surface suitability.
Freshly painted walls need up to 5 days to dry; newly plastered walls need up to 4 weeks.
Repositionable/low tack adhesives are unsuitable for coated or treated surfaces like stainless steel, brass, or bronze. Dusty surfaces can contaminate adhesive and reduce bond strength. Priming is recommended for these adhesives.
Wall temperature should be above +4°C, ideally above 10°C. Avoid applying to brick or heavily textured finishes unless using approved media like General Formulations’ RoughMark vinyl. Always test print first.
Priming the Walls
Priming reduces adhesive contamination, improves bond strength, counters wall moisture, and masks surface imperfections. Use a water-based eggshell or recognized wall primer and adhere to drying times.
Wall Graphic Printing & Artwork Considerations
Heavy deposits of uncured solvent or UV inks can affect film stability and adhesive strength. Fully cure, dry, and outgas prints before packaging or application, allowing 24 hours as a guide.
Polyester and PVC materials may shrink over time. Allow a 10mm overlap in prints. For textured surfaces, a larger overlap may be needed. For promotional applications, splice the join by overlapping and cutting through both layers to remove excess material.
How to Apply the Wall Graphic
For small decals:
- Remove the liner and position the graphic.
- Use a squeegee from the middle to the edges to avoid air bubbles.
- Ensure edges and corners are firmly attached.
For large decals:
- Lay face down, peel back part of the liner, and fold down.
- Align and apply the top portion with a squeegee.
- Slowly remove the remaining liner while pressing the decal to the wall.
- Work towards the edges to avoid air bubbles.
- Ensure edges and corners are firmly attached.
How to Remove the Wall Graphic
Gently peel from top to bottom at a 120-degree or greater angle using smooth, consistent force.
No liability for damage to painted surfaces as this depends on the paint-wall bond, which is beyond our control.
